CS Ceramic Co.,Ltd

Username : Password : Authcode :     Register
News & Events
Company News
Industry News
Product Category
All of Products
LECO Consumable and ...
Sample pan Alumina /...
Elementar ceramic co...
Bruker ceramic consu...
Alumina ceramic
Laboratory Porcelain
Platinum crucible
Fire assay crucible ...
Magnesia Cupel (Bone...
Dental zirconia bloc...
Graphite crucible
Zirconia Oxide Ceram...
OEM productions
Porcelain Insulator ...
Home » News & Events   
News & Events
test the sulfur in the iron and steel by burning and to determ
Post Time : 2013-7-10 7:17:56    Hits : 1442      Article Source : www.csceramic.com   
The carbon-sulfur element analyzer to test the sulfur in the iron and steel by burning and to determine how to select the standard sample
When testing the sulfur content in iron and steel with carbon-sulfur element analyzer by burning, the sulfur can not completely be transformed as sulfur dioxide, and the conversion rate is related to the experiment condition, the sulfur content in the sample can not be calculated directly with the academic value according to standard solution concentration. Therefore, the standard sample has to be used under the identical condition of the test sample to work out the sulfur titer and then work out the sulfur content in the test sample, thus the selection of the standard sample with sulfur shows gravely important.
When testing the sulfur with the carbon-sulfur analyzer by burning method, the weight-hour method, reduction-colorimetric method as well as the original potentiometric titration method will be selected to determine the value, and standard sample with similar mark number and similar content will be adopted to work out the titer and then work out the sulfur content.
The test results of carbon steel or pig iron stand sample which have been preserved for a very long time (such as those over 10 years) may turn out severe deviation, therefore, they will be used only after re-determining the value. The standard sample after use will be covered and put back to the dryer container as to avoid the chances of the carbon dioxide, sulfur dioxide, didrogen oxide in the air being attached to its surface from its exposure and influence the its standard value.
When testing the sample of sulfur content less than 0.010%, as introduced in GB223.2-1981, adopt 0.1000g standard sample with sulfur content over 0.10% and 0.9000g standard sample with sulfur content less than 0.001% and mix them to undertake the calibration. The blank value shall include those produced by porcelain boat, porcelain cover, fluxing agent as well as 0.9g standard sample with sulfur content less than 0.001 and etc. The sample will be in weight of 1.000g.
 Next :  Calibration method of carbon-sulfur united measurement analyzer  
 Prev :  Test carbon-sulfur in iron & steel  
Carbon & sulfur analyzer
Industrial ceramic
Metal Working
Iron & Steel lab
Engineered Ceramics
Mining Industry
Foundry steel
Coal industry
Precision Ceramics
Petrochemical &Chemical Industry
Chemistry laboratory
Physical Laboratory

Carbon Sulfur Crucibles
Sulfur Detection Crucibles
Refractory crucibles
Alumina crucibles
Volatilize Crucibles
Porcelain Mortar
Ceramic Boat
Evaporating Dish
Melting Crucible
Metal crucibles
Carbon Sulfur Crucible
Iron foundry
Steel foundry
Stainless steel casting
Copper casting
Gold melting

 E-MAIL:   TEL :0086-0731-23455639
Copyright © 2018 CS Ceramic Co.,Ltd      流量统计器